Yazar "Tuzlali, Mesut" seçeneğine göre listele
Listeleniyor 1 - 2 / 2
Sayfa Başına Sonuç
Sıralama seçenekleri
Öğe Comparison of marginal and internal adaptation of three-unit fixed dental prostheses made using CAD/CAM metal-free materials(Wiley, 2022) Baran, Melike Cigdem; Demirci, Fatih; Tuzlali, MesutThe aim of this study was to compare the marginal and internal adaptation of three-unit fixed dental prostheses (FDPs) fabricated from different metal-free materials using CAD/CAM methods. A total of 100 three-unit FDPs were produced from a cubic zirconia, a fiber-reinforced resin composite, a polyetheretherketone (PEEK), a polyetherketoneketone (PEKK), and a polymer composite material by the CAD/CAM method (n = 20 per material). The zirconia group was considered the control/reference material. Marginal and internal gap values of the produced FDPs were measured using the silicone replica method at x40 magnification under a stereomicroscope. The obtained data were analyzed using one-way ANOVA and Tukey's HSD tests. The marginal and internal gap values for the cubic zirconia material were found to be statistically significantly lower than those seen for the PEEK, polymer composite, PEKK, and fiber-reinforced resin composite materials. While the marginal and internal adaptation of the cubic zirconia material was found to be better than the others, it should be noted that the marginal and internal gap values for all other materials tested were found to be within the clinically acceptable range.Öğe Evaluation of the accuracy of dental casts manufactured with 3D printing technique in the All-on-4 treatment concept(Korean Acad Prosthodontics, 2022) Tas, Hilin; Demirci, Fatih; Tuzlali, Mesut; Bahce, Erkan; Avcu, Guler YildirimPURPOSE. The aim of this study is to compare the casts obtained by using conventional techniques and liquid crystal display (LCD) three-dimensional (3D) print techniques in the All-on-4 treatment concept of the edentulous mandibular jaw. MATERIALS AND METHODS. In this study, a completely edentulous mandibular acrylic cast (typodont) with bone-level implants placed with the All -on-4 technique served as a reference cast. In this typodont, impressions were taken with the conventional technique and dental stone casts were obtained. In addition, after scanning the acrylic cast in a dental laboratory scanner and obtaining the Standard Tessellation Language (STL) data, 3D printed casts were manufactured with a 3D printing device based on the design. The stone and 3D printed casts were scanned in the laboratory scanner and STL data were obtained, and then the interimplant distances were measured using Geomagic Control X v2020 (3D Systems, Rock Hill, SC, USA) analysis software (n = 60). The obtained data were statistically evaluated with one-way analysis of variance (ANOVA) and Tukey's pairwise comparison tests. RESULTS. As a result of the one-way ANOVA test, it was determined that the stone casts, 3D printed casts, and reference cast values in all distance intervals conformed to the normal distribution and these values had a significant difference among them in all distance intervals. In Tukey pairwise comparison test, significant differences were found between casts at all distance intervals. In all analyses, the level of significance was determined as .05. CONCLUSION. 3D printed casts obtained with a 3D LCD printing device can be an alternative to stone casts when implants are placed in edentulous jaws. [J Adv Prosthodont 2022;14:379-87]