Experimental Investigation of Delamination Formed by Bone Drilling

Basit Öğe Kaydı
dc.authoridbahçe, erkan/0000-0001-5389-5571
dc.authorwosidbahçe, erkan/AAQ-3631-2020
dc.contributor.authorKoluacik, Serdar
dc.contributor.authorCan, Murat
dc.contributor.authorBahce, Erkan
dc.date.accessioned2024-08-04T20:47:24Z
dc.date.available2024-08-04T20:47:24Z
dc.date.issued2020
dc.departmentİnönü Üniversitesien_US
dc.description.abstractBone drilling is a common method for fixing implants used in bone fractures. Because of the fibre-reinforced composite structure of bone, parameters such as feed rate, spindle speed and drill type affect the hole surface quality. After drilling, the quality of the bore surface, burr formation and delamination at the hole entrance and exit affect the ability of the screw to cause implant failure and fusion problems of the fracture. For this reason, it is very important to conduct drilling with optimum speed and feedrate values. In this study, the effects of processing parameters on hole surface quality and delamination were studied experimentally. In the experiment, bovine bone, which has similar structural properties to human bone, was used. The hole surface quality and delamination formed at the exit of the hole were examined for three different feed rates and spindle speeds. As a result of the experiments, it was seen that the feed rate had more effect on both delamination and hole surface quality than the spindle speed. It was also determined that the cortical part of the bone and the cancellous part of the bone affected the production of heat and drill wear differently.en_US
dc.description.sponsorshipOtimed Companyen_US
dc.description.sponsorshipWe thank Otimed Company for their support in performing this study.en_US
dc.identifier.doi10.17559/TV-20181228185947
dc.identifier.endpage717en_US
dc.identifier.issn1330-3651
dc.identifier.issn1848-6339
dc.identifier.issue3en_US
dc.identifier.scopus2-s2.0-85086501392en_US
dc.identifier.scopusqualityQ3en_US
dc.identifier.startpage711en_US
dc.identifier.urihttps://doi.org/10.17559/TV-20181228185947
dc.identifier.urihttps://hdl.handle.net/11616/99352
dc.identifier.volume27en_US
dc.identifier.wosWOS:000541512300005en_US
dc.identifier.wosqualityQ4en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherUniv Osijek, Tech Facen_US
dc.relation.ispartofTehnicki Vjesnik-Technical Gazetteen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectbone drillingen_US
dc.subjectdelaminationen_US
dc.subjectsurface qualityen_US
dc.titleExperimental Investigation of Delamination Formed by Bone Drillingen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu